WM8742GEDSSLASHV datasheet(42/66 Pages) CIRRUS

42 / 66 page

WM8742

Rev 4.4

ZERO FLAG

In hardware control mode the ZFLAG pin asserts when 1024 consecutive zero samples are applied to

the left and right channels of the WM8742 when in PCM mode. In DSD mode, the ZFLAG has no

function.

In hardware mode there is no access to the infinite zero detect and so there is no automute function.

If this functionality is required, software mode must be used.

Figure 27 shows the MUTEB and

ZFLAG configuration.

MUTEB

DINL

DINR

ZDET

ZFLAG

DAC

ANA

L&R

SOFT

L&R

DSD Direct

Figure 27 Hardware Control Mode MUTEB and ZFLAG Configuration

DE-EMPHASIS CONTROL AND ANTI-CLIPPING MODE

In hardware control mode, de-emphasis is supported with a maximum error of +1.5dB at a sampling

rate of 44.1kHz.

Audio material is regularly recorded up to 0dB level and heavily compressed. This causes clipping

and distortion when the digital media is applied to a DAC. In order to prevent this in the WM8742, an

anti-clipping mode is provided, which attenuates the digital signal by 2dB as it is processed through

the digital filters.

Under hardware control de-emphasis and the anti-clipping mode are only available when using PCM

mode.

NAME

DESCRIPTION

SDIN/

DEEMPH

Deemphasis Control

0 = De-emphasis off

1 = De-emphasis on

Z = Digital filter anti-clipping mode

Table 49 DEEMPH Hardware Control Pin Function

WM8742GEDS/V 데이터시트(PDF) 42 Page - Cirrus Logic