| 전자부품 데이터시트 검색엔진 |
|
PFS154 데이터시트(PDF) 86 Page - PADAUK Technology. |
|
|
|||||||||||||||||||||||||||||
PFS154 데이터시트(HTML) 86 Page - PADAUK Technology. |
|
86 / 91 page ![]() PFS154 8bit MTP Type IO Controller ©Copyright 2020, PADAUK Technology Co. Ltd Page 86 of 91 PDK-DS-PFS154_CN_V105 –Jun. 9, 2020 9. Special Notes This chapter is to remind user who use PFS154 series IC in order to avoid frequent errors upon operation. 9.1. Warning User must read all application notes of the IC by detail before using it. Please download the related application notes from the following link: http://www.padauk.com.tw/tw/technical/index.aspx 9.2. Using IC 9.2.1 IO pin usage and setting (1) IO pin is set to be digital input When IO is set as digital input, the level of Vih and Vil would changes with the voltage and temperature. Please follow the minimum value of Vih and the maximum value of Vil. The value of internal pull high resistor would also changes with the voltage, temperature and pin voltage. It is not the fixed value. (2) If IO pin is set to be digital input and enable wake-up function Configure IO pin as input Set corresponding bit to “1” in PXDIER For those IO pins of PA that are not used, PADIER[1:2] should be set low in order to prevent them from leakage. (3) PA5 is set to be output pin PA5 can be set to be Open-Drain output pin only, output high requires adding pull-up resistor. (4) PA5 is set to be PRSTB input pin Configure PA5 as input Set CLKMD.0=1 to enable PA5 as PRSTB input pin (5) PA5 is set to be input pin and to connect with a push button or a switch by a long wire Needs to put a >10 Ω resistor in between PA5 and the long wire Avoid using PA5 as input in such application. (6) PA7 and PA6 as external crystal oscillator Configure PA7 and PA6 as input Disable PA7 and PA6 internal pull-up resistor Configure PADIER register to set PA6 and PA7 as analog input EOSCR register bit [6:5] selects corresponding crystal oscillator frequency : 01 : for lower frequency, ex : 32KHz 10 : for middle frequency, ex : 455KHz, 1MHz 11 : for higher frequency, ex : 4MHz Program EOSCR.7 =1 to enable crystal oscillator Ensure EOSC working well before switching from IHRC or ILRC to EOSC |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |