USB3347CPTR datasheet(46/92 Pages) MICROCHIP

46 / 92 page

USB334x

DS00002646A-page 46

 2009-2018 Microchip Technology Inc.

NXT is used to throttle when the Link drives the register data on the bus. DIR is low throughout this transaction since

the PHY is receiving data from the Link. STP is used to end the transaction and data is registered after the de-assertion

of STP. After the write operation completes, the Link must drive a ULPI Idle (00h) on the data bus. If the databus is not

driven to idle the USB334x may decode the non-zero bus value as an RX Command.

A ULPI extended register write operation is shown in Figure 6-4. To write an extended register, the Link will wait until

DIR is low, and at T0, drive the TX CMD on the data bus. At T2 the PHY will drive NXT high. On the next clock T3 the

Link will drive the extended address. On the next rising clock edge, T4, the Link will write the register data. At T5, the

PHY will accept the register data and drive NXT low. The Link will drive an Idle on the bus and drive STP high to signal

the end of the data packet. At T5, the PHY will latch the data into the register. Finally, at T6, the Link will drive STP low.

FIGURE 6-4:

ULPI EXTENDED REGISTER WRITE IN SYNCHRONOUS MODE

DIR

CLK

DATA[7:0]

STP

NXT

TXD CMD

(extended reg write)

Idle

Reg Data[n]

Idle

ULPI Register

Reg Data [n-1]

Reg Data [n]

Extended

address

USB3347CPTR 데이터시트(PDF) 46 Page - Microchip Technology