| 전자부품 데이터시트 검색엔진 |
|
LTM4677 데이터시트(PDF) 73 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
LTM4677 데이터시트(HTML) 73 Page - Analog Devices |
|
73 / 110 page ![]() LTC3888-1 73 Rev. 0 For more information www.analog.com ON_OFF_CONFIG The ON_OFF_CONFIG command specifies the combination of RUN pin input state and PMBus commands needed to turn the addressed output rail on and off. Supported Values: VALUE MEANING 0x1F OPERATION value and RUN pin must both command the device to start/run. Device executes immediate off when commanded off. 0x1E OPERATION value and RUN pin must both command the device to start/run. Device uses TOFF_ command values when commanded off. 0x17 RUN pin control with immediate off when commanded off. OPERATION on/off control ignored. 0x16 RUN pin control using TOFF_ command values when commanded off. OPERATION on/off control ignored. Programming an unsupported ON_OFF_CONFIG value will generate a CML fault and the command will be ignored. This command has one data byte. ON, OFF AND MARGIN CONTROL COMMAND NAME CMD CODE DESCRIPTION TYPE PAGED DATA FORMAT UNITS NVM DEFAULT VALUE ON_OFF_CONFIG 0x02 RUN pin and PMBus on/off command configuration. R/W Byte Y Reg l 0x1E OPERATION 0x01 On, off and margin control. R/W Byte Y Reg l 0x80 MFR_RESET 0xFD Force full reset without removing power. Send Byte N MFR_CONFIG_ALL The MFR_CONFIG_ALL command provides device-level configuration common to multiple ADI PMBus products. Bit Definitions: BIT MEANING 7 Enable fault logging. 6 Ignore ILIM and PWM resistor configuration pins. 5 Disable CML fault for quick command message. 4 Disable SYNC output. 3 Enable 255ms PMBus timeout. 2 Require valid PEC for PMBus write. 1 Enable PMBus clock stretching. 0 Execute CLEAR_FAULTS when either channel is turned on by RUN pin or OPERATION command. If a legal command is received with an invalid PEC, the LTC3888-1 will not execute the command, regardless of the state of bit 2. If clock stretching is enabled, the LTC3888-1 only uses it as required, generally above SCL rates of 100kHz. This command has one data byte. PMBus COMMAND DETAILS (General Device Configuration/On, Off and Margin Control) |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |