AT25DF641A datasheet(41/58 Pages) DIALOG

41 / 58 page

AT25DF641A [DATASHEET]

8793F–DFLASH–11/2017

11.3 Write Status Register Byte 2

The Write Status Register Byte 2 command is used to modify the RSTE and SLE bits of the Status Register. Using the

Write Status Register Byte 2 command is the only way to modify the RSTE and SLE bits in the Status Register during

normal device operation, and the SLE bit can only be modified if the sector lockdown state has not been frozen. Before

the Write Status Register Byte 2 command can be issued, the Write Enable command must have been previously issued

to set the WEL bit in the Status Register to a Logical 1.

To issue the Write Status Register Byte 2 command, the CS pin must first be asserted and then the opcode 31h must be

clocked into the device followed by one byte of data. The one byte of data consists of three dummy bits, the RSTE bit

value, the SLE bit value, and three additional dummy bits (see Table 11-4). Any additional data bytes that are sent to the

device will be ignored. When the CS pin is deasserted, the RSTE and SLE bits in the Status Register will be modified,

and the WEL bit in the Status Register will be reset back to a Logical 0. The SLE bit will only be modified if the Freeze

Sector Lockdown State command has not been previously issued.

The complete one byte of data must be clocked into the device before the CS pin is deasserted, and the CS pin must be

deasserted on even byte boundaries (multiples of eight bits); otherwise, the device will abort the operation, the state of

the RSTE and SLE bits will not change, and the WEL bit in the Status Register will be reset back to the Logical 0 state.

Table 11-4. Write Status Register Byte 2 Format

Figure 11-3. Write Status Register Byte 2

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

RSTE

SLE

SCK

MSB

0011000

Opcode

10 11

814 15

MSB

XXX

Status Register In

Byte 2

High-impedance

AT25DF641A 데이터시트(PDF) 41 Page - Dialog Semiconductor