STM32F107RB datasheet(39/108 Pages) STMICROELECTRONICS

39 / 108 page

DocID15274 Rev 10

39/108

STM32F105xx, STM32F107xx

Electrical characteristics

107

5.3.4

Embedded reference voltage

The parameters given in Table 12 are derived from tests performed under ambient

temperature and VDD supply voltage conditions summarized in Table 9.

5.3.5

Supply current characteristics

The current consumption is a function of several parameters and factors such as the

operating voltage, ambient temperature, I/O pin loading, device software configuration,

operating frequencies, I/O pin switching rate, program location in memory and executed

binary code.

The current consumption is measured as described in Figure 9: Current consumption

measurement scheme.

All Run-mode current consumption measurements given in this section are performed with a

reduced code that gives a consumption equivalent to Dhrystone 2.1 code.

Maximum current consumption

The MCU is placed under the following conditions:

•

All I/O pins are in input mode with a static value at VDD or VSS (no load)

•

All peripherals are disabled except when explicitly mentioned

•

The Flash memory access time is adjusted to the fHCLK frequency (0 wait state from 0

to 24 MHz, 1 wait state from 24 to 48 MHz and 2 wait states above)

•

Prefetch in ON (reminder: this bit must be set before clock setting and bus prescaling)

•

When the peripherals are enabled fPCLK1 = fHCLK/2, fPCLK2 = fHCLK

The parameters given in Table 13, Table 14 and Table 15 are derived from tests performed

under ambient temperature and VDD supply voltage conditions summarized in Table 9.

Table 12. Embedded internal reference voltage

Symbol

Parameter

Conditions

Min

Typ

Max

Unit

VREFINT Internal reference voltage

–40 °C < TA < +105 °C 1.16

1.20

1.26

–40 °C < TA < +85 °C

1.16

1.20

1.24

TS_vrefint(1)

1. Shortest sampling time can be determined in the application by multiple iterations.

ADC sampling time when

reading the internal reference

voltage

5.1

17.1(2)

2. Guaranteed by design, not tested in production.

µs

VRERINT(2)

Internal reference voltage

spread over the temperature

range

VDD = 3 V ±10 mV

TCoeff(2) Temperature coefficient

100

ppm/°C

STM32F107RB 데이터시트(PDF) 39 Page - STMicroelectronics

STM32F107RB 데이터시트(HTML) 39 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL