AT24C01C datasheet(18/45 Pages) MICROCHIP

18 / 45 page

Write Operations

All write operations for the AT24C01C/AT24C02C begin with the master sending a Start condition,

followed by a device address byte with the R/W bit set to logic ‘0’, and then by the word address byte.

The data value(s) to be written to the device immediately follow the word address byte.

7.1

Byte Write

The AT24C01C/AT24C02C supports the writing of a single 8-bit byte. Selecting a data word in the

AT24C01C requires a 7-bit word address, while selecting a data word in the AT24C02C requires an 8-bit

word address.

Upon receipt of the proper device address and the word address bytes, the EEPROM will send an

Acknowledge. The device will then be ready to receive the 8-bit data word. Following receipt of the 8‑bit

data word, the EEPROM will respond with an ACK. The addressing device, such as a bus master, must

then terminate the write operation with a Stop condition. At that time, the EEPROM will enter an internally

self-timed write cycle, which will be completed within tWR, while the data word is being programmed into

the nonvolatile EEPROM. All inputs are disabled during this write cycle, and the EEPROM will not

respond until the write is complete.

Figure 7-1. Byte Write

SCL

SDA

Device Address Byte

Word Address Byte

Data Word

Start

Master

ACK

from

Slave

MSB

Stop

Master

MSB

D7 D6

D3 D2 D1

A6 A5

ACK

from

Slave

ACK

from

Slave

7.2

Page Write

A page write operation allows up to 8 bytes to be written in the same write cycle, provided all bytes are in

the same row of the memory array (where address bits A7 to A3 are the same). Partial page writes of less

than 8 bytes are also allowed.

A page write is initiated the same way as a byte write, but the bus master does not send a Stop condition

after the first data word is clocked in. Instead, after the EEPROM acknowledges receipt of the first data

word, the bus master can transmit up to seven additional data words. The EEPROM will respond with an

ACK after each data word is received. Once all data to be written has been sent to the device, the bus

master must issue a Stop condition (see Figure 7-2) at which time the internally self-timed write cycle will

begin.

The lower three bits of the word address are internally incremented following the receipt of each data

word. The higher order address bits are not incremented and retain the memory page row location. Page

write operations are limited to writing bytes within a single physical page, regardless of the number of

bytes actually being written. When the incremented word address reaches the page boundary, the

address counter will roll-over to the beginning of the same page. Nevertheless, creating a roll‑over event

should be avoided as previously loaded data in the page could become unintentionally altered.

AT24C01C/AT24C02C

Write Operations

Datasheet

DS20006111A-page 18

AT24C01C 데이터시트(PDF) 18 Page - Microchip Technology

AT24C01C 데이터시트(HTML) 18 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

데이터시트 다운로드

링크 URL