CDC930 datasheet(5/17 Pages) TI

5 / 17 page

SCAS641

– JULY 2000

POST OFFICE BOX 655303

DALLAS, TEXAS 75265

absolute maximum ratings over operating free-air temperature (unless otherwise noted)†

Supply voltage range, VDD

–0.5 V to 4.6 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

–0.5 V to VDD + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Voltage range applied to any output in the high-impedance state or power-off state,

VO (see Note 1)

–0.5 V to VDD + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Current into any output in the low state, IO

rated IOL

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0)

–18 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(VI < VDD)

18 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current , IOK (VO < 0)

–50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(VO < VDD)

50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance, JA (see Note 2)

74 C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Maximum power dissipation at TA = 55 C (in still air) (see Note 3)

1.3 W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operating free-air temperature range, TA

0 C to 85 C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range, Tstg

–65 C to 150 C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds

260 C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under

“recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.

2. The package thermal impedance is calculated in accordance with EIA/JEDEC Std JESD51, except for the through-hole packages,

which use a trace length of zero. The absolute maximum power dissipation allowed at TA = 55 C (in still air) is 1.3 W.

3. The maximum package power dissipation is calculated using a junction temperature of 1505C and a board trace length of 750 mils.

For more information, refer to the

application note in the

, literature number SCBD002.

DISSIPATION RATING TABLE

PACKAGE

TA 25 C

DERATING FACTOR‡

TA = 70 C

TA = 85 C

PACKAGE

POWER RATING

ABOVE TA = 25 C

POWER RATING

1558.6 mW

12.468 mW/ C

997.5 mW

810.52 mW

‡ This is the inverse of the traditional junction-to-case thermal resistance (R JA) and uses a board-mounted device

at 74 C/W.

CDC930 데이터시트(PDF) 5 Page - Texas Instruments

CDC930 데이터시트(HTML) 5 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

데이터시트 다운로드

링크 URL