ADC34RF52 datasheet(95/105 Pages) TI

95 / 105 page

8.5 Layout

8.5.1 Layout Guidelines

There are several critical signals which require specific care during board design:

1. Analog input and clock signals

• Traces should be as short as possible and vias should be avoided where possible to minimize impedance

discontinuities.

• Traces should be routed using loosely coupled 100-Ω differential traces.

• Differential trace lengths should be matched as close as possible to minimize phase imbalance and HD2

degradation.

2. Digital JESD204B output interface

• Traces should be routed using tightly coupled 100-Ω differential traces.

3. Power and ground connections

• Provide low resistance connection paths to all power and ground pins.

• Use power and ground planes instead of traces.

• Avoid narrow, isolated paths which increase the connection resistance.

• Use a signal/ground/power circuit board stackup to maximize coupling between the ground and power

plane.

8.5.2 Layout Example

The following screen shot shows the top layer of the ADC34RF52 EVM.

• The input signal traces are routed as differential signals on the top layer avoiding vias. Care is taken

to maintain symmetry between positive and negative input with matched trace length to minimize phase

imbalance.

Figure 8-11 shows the layout example for 1x and 2x averaging configuration

• JESD204B output interface lanes are routed differential and length matched

• Bypass caps are close to the power pins on the top layer avoiding vias.

JESD204B Lanes

Tightly coupled traces

Analog Inputs on top layer –

symmetric diﬀeren al

rou ng

Figure 8-11. Layout example: top layer of the EVM

www.ti.com

ADC34RF52

SBASAI7 – MARCH 2023

Submit Document Feedback

Product Folder Links: ADC34RF52

ADC34RF52 데이터시트(PDF) 95 Page - Texas Instruments