Production Data

WM8569

w

PD Rev 4.0 June 2006

7

Test Conditions

PARAMETER

SYMBOL

TEST CONDITIONS

MIN

TYP

MAX

UNIT

Mute Attenuation

1kHz Input, 0dB gain

90

dB

1kHz 100mVpp

50

dB

Power Supply Rejection Ratio

PSRR

20Hz to 20kHz

100mVpp

45

dB

Digital Logic Levels (CMOS Levels)

Input LOW level

0.3 x DVDD

V

Input HIGH level

0.7 x DVDD

V

Input leakage current

±0.2

±1

µA

Input capacitance

5

pF

Output LOW

0.1 x DVDD

V

Output HIGH

0.9 x DVDD

V

Analogue Reference Levels

Reference voltage

VREFP/2 –

50mV

VREFP/2

VREFP/2 +

50mV

V

Potential divider resistance

VREFP to VMID and

VMID to VREFN

50

kΩ

Supply Current

Analogue supply current

AVDD, VREFP = 5V

TBD

mA

Digital supply current

DVDD = 3.3V

TBD

mA

Notes:

1.

Ratio of output level with 1kHz full scale input, to the output level with all zeros into the digital input, measured ‘A’

weighted.

2.

All performance measurements done with 20kHz low pass filter, and where noted an A-weight filter. Failure to use

such a filter will result in higher THD+N and lower SNR and Dynamic Range readings than are found in the Electrical

Characteristics. The low pass filter removes out of band noise; although it is not audible it may affect dynamic

specification values.

3.

VMID decoupled with 10uF and 0.1uF capacitors (smaller values may result in reduced performance).

TERMINOLOGY

1.

Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full scale output and the output

with no signal applied. (No Auto-zero or Automute function is employed in achieving these results).

2.

Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal.

Normally a THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB

to it. (e.g. THD+N @ -60dB= -32dB, DR= 92dB).

3.

THD (dB) - THD is a ratio, of the rms values, of Distortion/Signal.

4.

Stop band attenuation (dB) - Is the degree to which the frequency spectrum is attenuated (outside audio band).

5.

Channel Separation (dB) - Also known as Cross-Talk. This is a measure of the amount one channel is isolated from

the other. Normally measured by sending a full scale signal down one channel and measuring the other.

6.

Pass-Band Ripple - Any variation of the frequency response in the pass-band region.