USB97C102 datasheet(28/80 Pages) SMSC

28 / 80 page

SMSC DS – USB97C102

Page 28

Rev. 03/23/2000

Table 33 - Wakeup Mask 1 Register

WU_MSK_1 (Note 1)

(0x7F2B - RESET=0x07 )

WAKEUP MASK 1

BIT

NAME

R/W

DESCRIPTION

[7:3]

Reserved

USB_Reset

R/W

External wakeup event.

0 = Enabled

1 = Masked

Resume

R/W

External wakeup event.

0 = Enabled

1 = Masked

Suspend

R/W

Internal wakeup event.

0 = Enabled

1 = Masked

Suspend – If 3ms of IDLE state are detected by the hardware,

then this bit, when set (1) will cause an interrupt to the MCU

Note 1: Interrupt events enabled by these bits are routed to the PWR_MNG Bit 0 in the ISR_1 register.

Table 34 - Wakeup Source 2 Register

WU_SRC_2

(0x7F2C - RESET=0x00)

WAKEUP SOURCE 2

BIT

NAME

R/W

DESCRIPTION

[7:4]

'0'

R/W

Reserved

IRQ3

R/W

External Interrupt state since WU_SRC_2 was last read.

0 = Unchanged

1 = Changed

IRQ2

R/W

External Interrupt state since WU_SRC_2 was last read.

0 = Unchanged

1 = Changed

IRQ1

R/W

External Interrupt state since WU_SRC_2 was last read.

0 = Unchanged

1 = Changed

IRQ0

R/W

External Interrupt state since WU_SRC_2 was last read.

0 = Unchanged

1 = Changed

Note 1: Any transition from high to low, or low to high on the associated input sets these bits.

Note 2: The bits in this register are cleared by writing a ‘1’ to the corresponding bit.

Note 3: Since this register will report any status change, when devices are to be powered down while monitored, the

appropriate bits must be masked until the device is armed correctly.

USB97C102 데이터시트(PDF) 28 Page - SMSC Corporation

USB97C102 데이터시트(HTML) 28 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

데이터시트 다운로드

링크 URL