ADS6445 datasheet(47/75 Pages) STMICROELECTRONICS

47 / 75 page

www.ti.com

fIN − Input Frequency − MHz

−6

−5

−4

−3

−2

−1

100

200

300

400

500

600

700

G073

Drive Circuit Requirements

ADS6445, ADS6444

ADS6443, ADS6442

SLAS531 – MAY 2007

APPLICATION INFORMATION (continued)

Figure 83. Analog Input Bandwidth (represented by magnitude of TF_ADC, see Figure 85 )

For optimum performance, the analog inputs must be driven differentially. This improves the common-mode

noise immunity and even order harmonic rejection.

A 5-

Ω resistor in series with each input pin is recommended to damp out ringing caused by the package

parasitics. It is also necessary to present low impedance (< 50

Ω) for the common mode switching currents. For

example, this is achieved by using two resistors from each input terminated to the common mode voltage

(VCM).

In addition to the above, the drive circuit may have to be designed to provide a low insertion loss over the

desired frequency range and matched impedance to the source. While doing this, the ADC input impedance has

to be taken into account. Figure 84 shows that the impedance (Zin, looking into the ADC input pins) decreases

at high input frequencies. The smith chart shows that the input impedance is capacitive and can be

approximated by a series R-C upto 500 MHz.

Submit Documentation Feedback

ADS6445 데이터시트(PDF) 47 Page - STMicroelectronics