| 전자부품 데이터시트 검색엔진 |
|
TMPR4937 데이터시트(PDF) 111 Page - Toshiba Semiconductor |
|
|
|||||||||||||||||||||||||||||
TMPR4937 데이터시트(HTML) 111 Page - Toshiba Semiconductor |
|
111 / 552 page ![]() Chapter 7 External Bus Controller 7-11 7.3.6.3 Ready Mode When in this mode, the ACK*/Ready pin becomes Ready input, and the cycle is ended by Ready input from an external device. Ready input is internally synchronized. See Section “7.3.7.5 Ready Input Timing” for more information regarding the operation timing. When the Wait cycle count specified by EBCCREBCCRn.PWT:WT elapses, a check is performed to see whether the Ready signal was asserted. Since EBCCRn.WT[0] is used to indicate the ACK*/ Ready Static/Dynamic mode, it is not used for setting the Wait cycle count. Therefore, the Wait cycle count that can be set by the Ready mode is 0, 2, 4, 6, …, 62. When the number of wait cycles is 0, Ready check is started in 1 cycle after asserting the CE* signal. When the number of wait cycle is other than zero, after waiting only for the specified number of cycles, Ready check is started. The Ready mode does not support Burst access by the internal bus. Figure 7.3.3 Ready Mode SYSCLK ADDR [19:0] OE* DATA [31:0] ACK*/READY (Input) EBCCRn.PWT:WT=2 CE* Start Ready Check EBCCRn.SHWT=0 |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |