LPC2917 datasheet(43/68 Pages) PHILIPS

43 / 68 page

LPC2917_19_1

Preliminary data sheet

Rev. 1.01 — 15 November 2007

43 of 68

NXP Semiconductors

LPC2917/19

ARM9 microcontroller with CAN and LIN

There are two primary clock generators: a low-power ring oscillator (LP_OSC) and a

crystal oscillator. See Figure 12.

LP_OSC is the source for the BASE_PCR_CLK that clocks the CGU itself and for

BASE_SAFE_CLK that clocks a minimum of other logic in the device (like the watchdog

timer). To prevent the device from losing its clock source LP_OSC cannot be put into

power-down. The crystal oscillator can be used as source for high-frequency clocks or as

an external clock input if a crystal is not connected.

Secondary clock generators are a PLL and seven fractional dividers (FDIV0..6). The PLL

has three clock outputs: normal, 120

° phase-shifted and 240° phase-shifted.

Configuration of the CGU: For every output generator - generating the base clocks - a

choice can be made from the primary and secondary clock generators according to

Figure 13.

Fig 12. Block diagram of the CGU

LP_OSC

Xtal

Oscilator

PLL

Clock Source Bus

Frequency

Monitor

Clock

Detection

DTL MMIO Interface

FDIV0

FDIV1

FDIV6

OUT 0

OUT 1

OUT 9

LPC2917 데이터시트(PDF) 43 Page - NXP Semiconductors