LPC2917 datasheet(2/68 Pages) PHILIPS

2 / 68 page

LPC2917_19_1

Preliminary data sheet

Rev. 1.01 — 15 November 2007

2 of 68

NXP Semiconductors

LPC2917/19

ARM9 microcontroller with CAN and LIN

2.2 ARM968E-S processor

The ARM968E-S is a general purpose 32-bit RISC processor, which offers high

performance and very low power consumption. The ARM architecture is based on

Reduced Instruction Set Computer (RISC) principles, and the instruction set and related

decode mechanism are much simpler than those of micro-programmed Complex

Instruction Set Computers (CISC). This simplicity results in a high instruction throughput

and impressive real-time interrupt response from a small and cost-effective controller

core.

Amongst the most compelling features of the ARM968E-S are:

• Separate directly connected instruction and data Tightly Coupled Memory (TCM)

interfaces

• Write buffers for the AHB and TCM buses

• Enhanced 16 x 32 multiplier capable of single-cycle MAC operations and 16-bit fixed-

point DSP instructions to accelerate signal-processing algorithms and applications.

Pipeline techniques are employed so that all parts of the processing and memory systems

can operate continuously. The ARM968E-S is based on the ARMv5TE five-stage pipeline

architecture. Typically, in a three-stage pipeline architecture, while one instruction is being

executed its successor is being decoded and a third instruction is being fetched from

memory. In the five-stage pipeline additional stages are added for memory access and

write-back cycles.

The ARM968E-S processor also employs a unique architectural strategy known as

THUMB, which makes it ideally suited to high-volume applications with memory

restrictions or to applications where code density is an issue.

The key idea behind THUMB is that of a super-reduced instruction set. Essentially, the

ARM968E-S processor has two instruction sets:

• Standard 32-bit ARMv5TE set

• 16-bit THUMB set

The THUMB set's 16-bit instruction length allows it to approach twice the density of

standard ARM code while retaining most of the ARM's performance advantage over a

traditional 16-bit controller using 16-bit registers. This is possible because THUMB code

operates on the same 32-bit register set as ARM code.

THUMB code can provide up to 65 % of the code size of ARM, and 160 % of the

performance of an equivalent ARM controller connected to a 16-bit memory system.

The ARM968E-S processor is described in detail in the ARM968E-S data sheet Ref. 2.

2.3 On-chip flash memory system

The LPC2917/19 includes a 512 kB or 768 kB flash memory system. This memory can be

used for both code and data storage. Programming of the flash memory can be

accomplished in several ways. It may be programmed in-system via a serial port; e.g.

CAN.

LPC2917 데이터시트(PDF) 2 Page - NXP Semiconductors

LPC2917 데이터시트(HTML) 2 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

데이터시트 다운로드

링크 URL