M41T83RM6F datasheet(15/64 Pages) STMICROELECTRONICS

15 / 64 page

DocID012578 Rev 19

15/64

M41T82, M41T83

Operation

2.2

Read mode

In this mode the master reads the M41T8x slave after setting the slave address (see

Figure 13 on page 16

). Following the WRITE mode control bit (R/W = 0) and the

acknowledge bit, the word address 'An' is written to the on-chip address pointer. Next the

START condition and slave address are repeated followed by the READ mode control bit

(R/W = 1). At this point the master transmitter becomes the master receiver. The data byte

which was addressed will be transmitted and the master receiver will send an acknowledge

bit to the slave transmitter. The address pointer is only incremented on reception of an

acknowledge clock. The M41T8x slave transmitter will now place the data byte at address

An+1 on the bus, the master receiver reads and acknowledges the new byte and the

address pointer is incremented to An+2.

This cycle of reading consecutive addresses will continue until the master receiver sends a

STOP condition to the slave transmitter. Most of the registers and memory locations are

accessed directly, but the RTC counters are accessed via a set of buffer/transfer registers at

addresses 00h to 07h. The counters are not directly read nor written. Instead, at the start of

a read or write cycle, the counters are copied into the eight buffer/transfer registers so that

the user can read them out sequentially, receiving a coherent set of data, copied from the

same instant in time.

An alternate READ mode may also be implemented whereby the master reads the M41T8x

slave without first writing to the (volatile) address pointer. The first address that is read is the

last one stored in the pointer (see Figure 14 on page 16).

Figure 12. Slave address location

AI00602

R/W

SLAVE ADDRESS

START

M41T83RM6F 데이터시트(PDF) 15 Page - STMicroelectronics