IMXRT1160AXEC datasheet(39/130 Pages) NXP

39 / 130 page

Electrical characteristics

i.MX RT1160 Crossover Processors Data Sheet for Extended Industrial Products, Rev. 4, 06/2025

NXP Semiconductors

For additional information, see the i.MX RT1160 Reference Manual (IMXRT1160RM).

4.2.5

PLL’s electrical characteristics

This section provides PLL electrical characteristics.

NOTE

The output frequency of Audio PLL and Video PLL (including post divider

inside PLL module if there is) should be not greater than 1GHz on over drive

mode, 800MHz on normal drive mode and 480MHz on under drive mode.

The output frequency of Arm PLL (including post divider inside PLL

module if there is) should be not greater than 600MHz on over drive mode

and normal drive mode and not greater than 480MHz on under drive mode.

• DCDC Run mode

-2.5%

—

2.5%

—

Maximum 50 mV

Vp-p@vdd1p0

• DCDC Low power mode

-6%

—

Over current detection

—

1.5

—

The typical value can be

configured as 1.5 A and

2 A by register.

Over voltage detection

• Output 1.8 V

—

2.5

2.75

—

• Output 1.0 V

—

1.5

1.65

—

• Low DCDC_IN detection

—

2.6

2.8

—

Leakage current

—



DCDC off

Quiescent current

• DCDC Run mode

—

150

—



—

• DCDC Low power mode

—



—

Capacitor value

—

(DCDC_ANA)

(DCDC_DIG)

—



High frequency

capacitor are also

required.

Inductor value

—

4.7

—



—

• Saturation current

—

1 Values in this table are based on CZ test with limited matrix samples in lab environment.

Table 21. DCDC characteristics1

Description

Min

Typ

Max

Unit

Comments

IMXRT1160AXEC 데이터시트(PDF) 39 Page - NXP Semiconductors

IMXRT1160AXEC 데이터시트(HTML) 39 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL