PicoScope® 6000E Series

Probe positioning system

The Pico oscilloscope probe positioning system holds your circuit board firmly and keeps multiple probes positioned, hands-free, during

inspection and test.

The kits include flexible probe holders with magnetic bases which secure to the steel base plate. When the probes are installed in the holders

they can be positioned to make contact with test points on the circuit board and will remain situated while you take measurements in the

PicoScope software.

The steel base plate is mirror-finished, reflecting any items such as status LEDs on the underside of the PCB, for easy visibility.

Probe positioning system kit contents

Item

PQ215 kit

PQ219 kit

PQ218 kit

PCB holder

4

4

-

Base plate, 210 x 297 mm

1

1

-

Set of insulation washers for PCB holders

1

1

-

Pico probe holder, 2.5 mm

4

8

4

Set of cable holders channels A-D

1

1

1

Set of cable holders channels E-H

1

1

1

P2056 500 MHz 10:1 passive BNC probe

4

If you own a 4- or

8-channel scope with

four probes, this kit is

the ideal add-on.

Upgrade your 8-channel

scope from four to

eight probes, and add

eight probe holders.

Four extra probe

holders.

Passive analog high- and low-impedance probes

P2056 500 MHz and P2036 300 MHz high-impedance passive probes are supplied with your scope and are also

available separately. The PicoScope 6428E-D is not supplied with probes.

Supplied in single or dual packs, these probes feature a probe-detect readout BNC connector allowing automatic

recognition as a 10:1 attenuator by the oscilloscope. They are high frequency response trimmed to match the

oscilloscope and supplied in single or dual packs.

A TA062 1.5 GHz low-impedance 10:1 passive oscilloscope probe with BNC is available separately in a single pack.

A comprehensive selection of accessories is supplied in the single probe packs and a basic selection in the dual

packs. Further accessories are available as listed in the P2056 and P2036 User’s Guide.

Optional accessories