PicoScope® 6000E Series

PicoScope model:

6426E

6425E

6824E

6424E

6406E

6405E

6804E

6404E

6403E

6428E-D

DeepMeasure™

Parameters

Cycle number, cycle time, frequency, low pulse width, high pulse width, duty cycle (high), duty cycle (low), rise time, fall time, undershoot, overshoot, max. voltage, min. voltage, voltage

peak to peak, start time, end time

Serial decoding

Protocols

1-Wire, ARINC 429, BroadRReach, CAN, CAN FD, CAN J1939, CAN XL, DALI, DCC, DMX512, Ethernet 10BASE-T, Extended UART, Fast Ethernet 100BASE-TX, FlexRay, I2C, I2S, I3C BASIC

v1.0, LIN, Manchester, MIL-STD-1553, MODBUS ASCII, MODBUS RTU, NMEA-0183, Parallel Bus, PMBus, PS/2, PSI5 (Sensor), Quadrature, RS232/UART, SBS Data, SENT Fast, SENT Slow,

SENT SPC, SMBus, SPI-MISO/MOSI, SPI-SDIO, USB (1.0/1.1), Wind Sensor

Mask limit testing

Statistics

Pass/fail, failure count, total count

Mask creation

Auto-generated from waveform or imported from file

Display

Display modes

Scope, XY scope, persistence, spectrum.

Interpolation

Linear or sin(x)/x

Persistence modes

Time, frequency, fast

Output file formats

csv, mat, pdf, png, psdata, pssettings, txt

Output functions

Copy to clipboard, print

Data transfer

Captured waveform data USB transfer

rate to PC

On USB 3.0, PC-dependent: 8-bit mode: up to 360 MS/s; 10-bit/12-bit modes: up to 180 MS/s

On USB 2.0, PC-dependent: 8-bit mode: up to 40 MS/s; 10-bit/12-bit modes: up to 20 MS/s

Hardware accelerated waveform

display rate

Hardware acceleration enables up to 4 GS of data to be displayed on screen per second (8-bit mode, 4 channels, 500 MS per channel at max sample rate)

General specifications

PC connectivity

USB 3.0 SuperSpeed (USB 2.0 compatible)

PC connector type

USB Type B

Power requirement

12 V DC from supplied PSU. Up to 5 A (scope only) or 7 A including scope-powered accessories

Ground terminal

Functional ground terminal accepting wire or 4 mm plug, rear-panel

Thermal management

Automatic fan speed control for low noise

Dimensions

245 x 192 x 61.5 mm

Weight

2.2 kg (scope only)

5.6 kg (in carry case with PSU and cables)

Ambient

temperature

range

Operating

0 to 40 °C

For quoted accuracy 15 to 30 °C after 20-minute warm-up

Storage

–20 to +60 °C

Humidity range

Operating

5 to 80 %RH non-condensing

Storage

5 to 95 %RH non-condensing

Altitude range

Up to 2000 m

Pollution degree

EN 61010 pollution degree 2: “only nonconductive pollution occurs except that occasionally a temporary conductivity caused by condensation is expected”

Safety compliance

Designed to EN 61010-1:2010 + A1:2019

EMC compliance

Tested to EN 61326-1:2013 and FCC Part 15 Subpart B