8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

BATTERY CHARGING

The battery will have been shipped in a low charge state and will require

charging before first time use.

1. Press the battery release clip on

the front of the battery pack.

2. Slide the battery pack from the

impact wrench.

3. Plug the charger into a 230V

power supply and switch ON.

• The green POWER ON light will

illuminate to show the unit is

connected to the mains supply.

4. Insert the battery pack into the

battery charger, as shown, noting

that it will only fit one way.

• The red light will come on to

indicate the battery is charging.

• When charging is complete, the

red light will go off and the

green light will come on. The

battery pack can be

considered charged and be

removed. Charging time will be

dependant upon the initial state

of the battery.

• When charging a new battery pack, it may initially not accept full

charge. This is common & does not indicate a fault. It can be

recharged fully after it has been discharged a couple of times.

• If charging does not take place, ensure all connections are clean.

• In the event of both LED indicators flashing rapidly, it can be

assumed that either the battery has become too hot, in which case

it should be left to cool down, or that a battery cell has failed and

the battery should be replaced.

5. After charging, switch off and unplug the charger from the power supply.

6. Remove the battery pack from the charger and slide it back onto the

impact wrench until it clips into place.