resistor connected to any voltage rail less than VIN. The PG signal can be used for sequencing of multiple rails

by connecting to the EN pin of other converters. If not used, the PG pin can be left floating or connected to GND.

Table 8-2. Power Good Pin Logic

DEVICE STATE

PG LOGIC STATUS

HIGH IMPEDANCE

LOW

Enabled (EN = High)

0.57V ≤ VFB ≤ 0.642V

√

VFB < 0.54V or VFB > 0.66V

√

Shutdown (EN = Low)

√

UVLO

2V ≤ VIN < VUVLO

√

Thermal Shutdown

TJ > TJSD

√

Power Supply Removal

VIN < 2V

√

The PG pin has a 40μs deglitch time on the falling edge.

8.3.8 Thermal Shutdown

The junction temperature (TJ) of the device is monitored by an internal temperature sensor. If TJ exceeds 170°C

(typ), the device goes into thermal shutdown. Both the high-side and low-side power FETs are turned off and

PG goes low. When TJ decreases below the hysteresis amount of typically 15°C, the converter resumes normal

operation, beginning with soft start. During PFM, the thermal shutdown is not active.

8.4 Device Functional Modes

8.4.1 Pulse Width Modulation (PWM) Operation

The TPSM8281x has two operating modes: Forced PWM mode and PFM/PWM mode.

With the MODE/SYNC pin set to high, the TPSM8281x operates with pulse width modulation in continuous

conduction mode (CCM). The switching frequency is either defined by a resistor from the COMP/FSET pin to

GND or by an external clock signal applied to the MODE/SYNC pin.

8.4.2 Power Save Mode Operation (PFM/PWM)

When the MODE/SYNC pin is low, power save mode is allowed. The device operates in PWM mode as long

as the peak inductor current is above the PFM threshold of about 1.2A. When the peak inductor current drops

below the PFM threshold, the device starts to skip switching pulses.

In power save mode, the switching frequency decreases linearly with the load current to maintain high efficiency.

The linear behavior of the switching frequency in power save mode is shown in Figure 8-1.

Figure 8-1. Switching Frequency versus Output Current (VIN = 5V, VOUT = 1.8V, RCF = 8.06kΩ)

www.ti.com

TPSM82810, TPSM82813

SLUSDN6D – SEPTEMBER 2019 – REVISED JUNE 2026

Copyright © 2026 Texas Instruments Incorporated

Submit Document Feedback

13

Product Folder Links: TPSM82810 TPSM82813