16

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MOUNTING THE WELDING WIRE SPOOL

NOTE: Spools of welding wire are available from your CLARKE dealer.

1. Open the side panel by pushing

the latch down and allowing the

side panel to open.

2. Remove the locking wingnut and

retaining disc.

3. Place a spool of welding wire over

the spindle.

• DO NOT release the tension on

the wire, as it will unravel

causing feeding problems later.

• The wire will feed off the spool clockwise from the top of the reel.

• The spool must be fitted in the correct orientation otherwise it will not

feed correctly.

SETTING THE DRIVE ROLLER SIZE

1. Loosen the tensioning knob and

pivot it towards you.

2. Lift up the arm.

3. Take hold of the triangular knob

on the drive roller cover and

rotate it 90°anticlockwise to

release it.

4. Pull the roller retainer off the drive

spindle to reveal the roller.

5. Pull the roller off the drive spindle.

• The groove size is stamped on the corresponding side of the roller.

Select the groove size according to the size of the wire you are using

and put the roller back on the spindle with your chosen side facing

you.

6. Replace the drive roller cover back onto the drive spindle with the opening

facing right.

WARNING: MAKE SURE THAT THE WELDER IS NOT CONNECTED TO THE

MAINS SUPPLY.