18

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

10. Release the trigger and switch off the welder and disconnect the machine

from the mains supply.

11. Refit the appropriate size contact tip (the 0.9 mm tip, for no gas welding is

supplied fitted) to suit your wire and replace the shroud.

• A spare 0.8 mm tip is supplied loose and should be used when using

0.6/0.8 mm mild steel solid wire.

12. Trim the welding wire so that it protrudes no more than 5 mm from the end

of the contact tip.

GAS/NO-GAS SELECTION

The welder can be configured to

weld, with or without a gas supply

according to the type of welding

wire being used.

• Mild steel solid core (With Gas)

• Flux cored (No Gas)

WELDING WITHOUT GAS

1. If using 0.9mm flux cored wire,

connect the terminal as shown.

• The earth cable (Thicker Lead)

should be connected to the

positive (Red) terminal.

• The cable from torch (Thinner

Lead) should be connected to

the Negative (Black) terminal.

WELDING WITH GAS

1. If using solid cored wire 0.6/0.8mm

wire, connect the terminal as

shown.

• The earth cable (Thicker Lead)

should be connected to the

negative (Black) terminal.

• The cable from torch (Thinner

Lead) should be connected to

the positive (Red) terminal.