DP80390 datasheet(58/84 Pages) DCD

58 / 84 page

DP80390 Instructions set details

- 58 -

All trademarks mentioned in this document

http://www.DigitalCoreDesign.com

are trademarks of their respective owners.

http://www.dcd.pl

3.25.

MOVC*

Instruction:

MOVC A, @A + <base-reg>

Function:

Move code byte

Description:

The MOVC instructions load the accumulator with a code byte, or

constant from program memory. The address of the byte fetched is the

sum of the original unsigned eight-bit accumulator contents and the

contents of a 16-bit/24-bit base register, which may be either the data

pointer or the PC. In the latter case, the PC is incremented to the

address of the following instruction before being added to the

accumulator; otherwise the base register is not altered. 16-bit/24-bit

addition is performed so a carry-out from the low-order eight bits may

propagate through higher-order bits. No flags are affected.

3.25.1.

MOVC A, @A + DPTR

Operation:

(PC)

← (PC) + 1

(A)

← ((A) + (DPTR))

Bytes:

Cycles:

Encoding:

3.25.2.

MOVC A, @A + PC

Operation:

(PC)

← (PC) + 1

(A)

← ((A) + (PC))

Bytes:

Cycles:

Encoding:

* different registers are used in FLAT and LARGE mode

DP80390 데이터시트(PDF) 58 Page - Digital Core Design

DP80390 데이터시트(HTML) 58 Page - Digital Core Design

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

데이터시트 다운로드

링크 URL