| 전자부품 데이터시트 검색엔진 |
|
R8C2K 데이터시트(PDF) 162 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
R8C2K 데이터시트(HTML) 162 Page - Renesas Technology Corp |
|
162 / 471 page ![]() R8C/2K Group, R8C/2L Group 16. Timers Rev.1.10 Dec 21, 2007 Page 145 of 450 REJ09B0406-0110 16.1.4 Pulse Width Measurement Mode In pulse width measurement mode, the pulse width of an external signal input to the INT1/TRAIO pin is measured (refer to Table 16.5 Pulse Width Measurement Mode Specifications). Figure 16.8 shows the TRAIOC Register in Pulse Width Measurement Mode and Figure 16.9 shows an Operating Example of Pulse Width Measurement Mode. Table 16.5 Pulse Width Measurement Mode Specifications Item Specification Count sources f1, f2, f8, fOCO Count operations • Decrement • Continuously counts the selected signal only when measurement pulse is “H” level, or conversely only “L” level. • When the timer underflows, the contents of the reload register are reloaded and the count is continued. Count start condition 1 (count starts) is written to the TSTART bit in the TRACR register. Count stop conditions • 0 (count stops) is written to the TSTART bit in the TRACR register. • 1 (count forcibly stops) is written to the TSTOP bit in the TRACR register. Interrupt request generation timing • When timer RA underflows [timer RA interrupt]. • Rising or falling of the TRAIO input (end of measurement period) [timer RA interrupt] INT1/TRAIO pin function Measured pulse input (INT1 interrupt input) Read from timer The count value can be read by reading registers TRA and TRAPRE. Write to timer • When registers TRAPRE and TRA are written while the count is stopped, values are written to both the reload register and counter. • When registers TRAPRE and TRA are written during the count, values are written to the reload register and counter. (Refer to 16.1.1.1 Timer Write Control during Count Operation.) Select functions • Measurement level select The TEDGSEL bit in the TRAIOC register selects the “H” or “L” level period. • Measured pulse input pin select function P1_7 or P1_5 is selected by the TIOSEL bit in the TRAIOC register. • Digital filter function Bits TIPF0 and TIPF1 in the TRAIOC register enable or disable the digital filter and select the sampling frequency. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |