M16CSLASH29 datasheet(376/499 Pages) RENESAS

376 / 499 page

20. Flash Memory Version

page 352

20.8.4 Full Status Check

If an error occurs, bits FMR06 to FMR07 in the FMR0 register are set to 1, indicating a specific error.

Therefore, execution results can be comfirmed by verifying these status bits (full status check).

Table 20.7

lists errors and FMR0 register state. Figure 20.14 shows a flow chart of the full status check

and handling procedure for each error.

Table 20.7 Errors and FMR0 Register Status

FMR0 register

(SRD register)

status

Error

Error occurrence condition

FMR07

FMR06

(SR5)

(SR4)

Command

• An incorrect commands is written

sequence error • A value other than xxD016 or xxFF16 is written in the second bus

cycle of the block erase command (1)

• When the block erase command is executed on an protected block

• When the program command is executed on protected blocks

Erase error

• The block erase command is executed on an unprotected block

but the program operation is not successfully completed

Program error • The program command is executed on an unprotected block but

the program operation is not successfully completed

Note 1: The flash memory enters read array mode by writing command code xxFF16 in the second bus

cycle of these commands. The command code written in the first bus cycle becomes invalid.

M16C/29 데이터시트(PDF) 376 Page - Renesas Technology Corp