HD6432351 datasheet(560/1025 Pages) RENESAS

560 / 1025 page

Section 11 Programmable Pulse Generator (PPG)

Rev. 3.00 Sep 15, 2006 page 526 of 988

REJ09B0330-0300

[1] Set up the TPU channel to be used as the output trigger channel so that TGRA and TGRB are

output compare registers. Set the trigger period in TGRB and the non-overlap margin in

TGRA, and set the counter to be cleared by compare match B. Set the TGIEA bit in TIER to 1

to enable the TGIA interrupt.

[2] Write H'FF in P1DDR and NDERH, and set the G3CMS1, G3CMS0, G2CMS1, and G2CMS0

bits in PCR to select compare match in the TPU channel set up in the previous step to be the

output trigger. Set the G3NOV and G2NOV bits in PMR to 1 to select non-overlapping output.

Write output data H'95 in NDRH.

[3] The timer counter in the TPU channel starts. When a compare match with TGRB occurs,

outputs change from 1 to 0. When a compare match with TGRA occurs, outputs change from 0

to 1 (the change from 0 to 1 is delayed by the value set in TGRA). The TGIA interrupt

handling routine writes the next output data (H'65) in NDRH.

[4] Four-phase complementary non-overlapping pulse output can be obtained subsequently by

writing H'59, H'56, H'95... at successive TGIA interrupts. If the DTC or DMAC is set for

activation by this interrupt, pulse output can be obtained without imposing a load on the CPU.

HD6432351 데이터시트(PDF) 560 Page - Renesas Technology Corp