HD64F2149YV datasheet(398/1075 Pages) RENESAS

398 / 1075 page

Section 12 8-Bit Timers

Rev. 3.00 Jan 18, 2006 page 370 of 1044

REJ09B0280-0300

12.3.5

Operation with Cascaded Connection

If bits CKS2 to CKS0 in either TCR0 or TCR1 are set to B'100, the 8-bit timers of the two

channels are cascaded. With this configuration, a single 16-bit timer can be used (16-bit timer

mode) or compare-matches of 8-bit channel 0 can be counted by the timer of channel 1 (compare-

match count mode). In this case, the timer operates as described below.

16-Bit Count Mode: When bits CKS2 to CKS0 in TCR0 are set to B'100, the timer functions as a

single 16-bit timer with channel 0 occupying the upper 8 bits and channel 1 occupying the lower 8

bits.

• Setting of compare-match flags

 The CMF flag in TCSR0 is set to 1 when a 16-bit compare-match occurs.

 The CMF flag in TCSR1 is set to 1 when a lower 8-bit compare-match occurs.

• Counter clear specification

 If the CCLR1 and CCLR0 bits in TCR0 have been set for counter clear at compare-match,

the 16-bit counter (TCNT0 and TCNT1 together) is cleared when a 16-bit compare-match

occurs. The 16-bit counter (TCNT0 and TCNT1 together) is cleared even if counter clear

by the TMRI0 pin has also been set.

 The settings of the CCLR1 and CCLR0 bits in TCR1 are ignored. The lower 8 bits cannot

be cleared independently.

• Pin output

 Control of output from the TMO0 pin by bits OS3 to OS0 in TCSR0 is in accordance with

the 16-bit compare-match conditions.

 Control of output from the TMO1 pin by bits OS3 to OS0 in TCSR1 is in accordance with

the lower 8-bit compare-match conditions.

Compare-Match Count Mode: When bits CKS2 to CKS0 in TCR1 are B'100, TCNT1 counts

compare-match A’s for channel 0.

Channels 0 and 1 are controlled independently. Conditions such as setting of the CMF flag,

generation of interrupts, output from the TMO pin, and counter clearing are in accordance with the

settings for each channel.

Usage Note: If the 16-bit count mode and compare-match count mode are set simultaneously, the

input clock pulses for TCNT0 and TCNT1 are not generated and thus the counters will stop

operating. Simultaneous setting of these two modes should therefore be avoided.

HD64F2149YV 데이터시트(PDF) 398 Page - Renesas Technology Corp