HD64F2149YV datasheet(495/1075 Pages) RENESAS

495 / 1075 page

Section 15 Serial Communication Interface (SCI, IrDA)

Rev. 3.00 Jan 18, 2006 page 467 of 1044

REJ09B0280-0300

15.3.3

Multiprocessor Communication Function

The multiprocessor communication function performs serial communication using a

multiprocessor format, in which a multiprocessor bit is added to the transfer data, in asynchronous

mode. Use of this function enables data transfer to be performed among a number of processors

sharing transmission lines.

When multiprocessor communication is carried out, each receiving station is addressed by a

unique ID code.

The serial communication cycle consists of two component cycles: an ID transmission cycle

which specifies the receiving station, and a data transmission cycle. The multiprocessor bit is used

to differentiate between the ID transmission cycle and the data transmission cycle.

The transmitting station first sends the ID of the receiving station with which it wants to perform

serial communication as data with a 1 multiprocessor bit added. It then sends transmit data as data

with a 0 multiprocessor bit added.

The receiving station skips the data until data with a 1 multiprocessor bit is sent.

When data with a 1 multiprocessor bit is received, the receiving station compares that data with its

own ID. The station whose ID matches then receives the data sent next. Stations whose ID does

not match continue to skip the data until data with a 1 multiprocessor bit is again received. In this

way, data communication is carried out among a number of processors.

Figure 15.9 shows an example of inter-processor communication using a multiprocessor format.

Data Transfer Format

There are four data transfer formats.

When a multiprocessor format is specified, the parity bit specification is invalid.

For details, see table 15.10.

HD64F2149YV 데이터시트(PDF) 495 Page - Renesas Technology Corp