HD64F2149YV datasheet(191/1075 Pages) RENESAS

191 / 1075 page

Section 6 Bus Controller

Rev. 3.00 Jan 18, 2006 page 163 of 1044

REJ09B0280-0300

6.5.3

Wait Control

As with the basic bus interface, either program wait insertion or pin wait insertion using the

WAIT

pin can be used in the initial cycle (full access) of the burst ROM interface. See section 6.4.5, Wait

Control.

Wait states cannot be inserted in a burst cycle.

6.6

Idle Cycle

6.6.1

Operation

When the H8S/2169 or H8S/2149 chip accesses external space, it can insert a 1-state idle cycle

I) between bus cycles when a write cycle occurs immediately after a read cycle. By inserting an

idle cycle it is possible, for example, to avoid data collisions between ROM, with a long output

floating time, and high-speed memory, I/O interfaces, and so on.

If an external write occurs after an external read while the ICIS0 bit in BCR is set to 1, an idle

cycle is inserted at the start of the write cycle. This is enabled in advanced mode and normal

mode.

Figure 6.15 shows an example of the operation in this case. In this example, bus cycle A is a read

cycle from ROM with a long output floating time, and bus cycle B is a CPU write cycle. In (a), an

idle cycle is not inserted, and a collision occurs in cycle B between the read data from ROM and

the CPU write data. In (b), an idle cycle is inserted, and a data collision is prevented.

HD64F2149YV 데이터시트(PDF) 191 Page - Renesas Technology Corp