HD64F2149YV datasheet(221/1075 Pages) RENESAS

221 / 1075 page

Section 7 Data Transfer Controller

Rev. 3.00 Jan 18, 2006 page 193 of 1044

REJ09B0280-0300

7.3.11

Procedures for Using the DTC

Activation by Interrupt: The procedure for using the DTC with interrupt activation is as follows:

1. Set the MRA, MRB, SAR, DAR, CRA, and CRB register information in the on-chip RAM.

2. Set the start address of the register information in the DTC vector address.

3. Set the corresponding bit in DTCER to 1.

4. Set the enable bits for the interrupt sources to be used as the activation sources to 1. The DTC

is activated when an interrupt used as an activation source is generated.

5. After the end of one data transfer, or after the specified number of data transfers have ended,

the DTCE bit is cleared to 0 and a CPU interrupt is requested. If the DTC is to continue

transferring data, set the DTCE bit to 1.

Activation by Software: The procedure for using the DTC with software activation is as follows:

1. Set the MRA, MRB, SAR, DAR, CRA, and CRB register information in the on-chip RAM.

2. Set the start address of the register information in the DTC vector address.

3. Check that the SWDTE bit is 0.

4. Write 1 in the SWDTE bit and the vector number to DTVECR.

5. Check the vector number written to DTVECR.

6. After the end of one data transfer, if the DISEL bit is 0 and a CPU interrupt is not requested,

the SWDTE bit is cleared to 0. If the DTC is to continue transferring data, set the SWDTE bit

to 1. When the DISEL bit is 1, or after the specified number of data transfers have ended, the

SWDTE bit is held at 1 and a CPU interrupt is requested.

HD64F2149YV 데이터시트(PDF) 221 Page - Renesas Technology Corp