M32CSLASH86 datasheet(432/505 Pages) RENESAS

432 / 505 page

Page 409

25. Flash Memory Version

)

(

25.3.5.6 Erase All Unlocked Block Command

The erase all unlocked block command erases all blocks except the block A.

By writing command code "xxA716" in the first bus cycle and "xxD016" in the second bus cycle, auto

erase (erase and verify) operation will run continuously in all blocks except the block A.

The FMR00 bit in the FMR0 register indicates whether or not an auto erase operation has been

completed.

After the completion of an auto erase operation, the FMR07 bit in the FMR0 register indicates whether

or not the auto erase operation has been completed as expected.

The lock bit can protect each block from being programmed inadvertently. (Refer to 25.3.6 Data

Protect Function.)

In EW mode 1, do not execute this command when the lock bit for any block storing the rewrite control

program is set to "1" (unlocked) or when the FMR02 bit in the FMR0 register is set to "1" (lock bit

disabled).

In EW mode 0, the microcomputer enters read status register mode as soon as an auto erase opera-

tion starts. The SRD register can be read. The SR7 bit in the SRD register is set to "0" (busy) at the

same time an auto erase operation starts. It is set to "1" (ready) when an auto erase operation is

completed. The microcomputer remains in read status register mode until the read array command or

read lock bit status command is written.

Only blocks 0 to 12 can be erased by the erase all unlocked block command. The block A cannot be

erased. Use the block erase command to erase the block A.

M32C/86 데이터시트(PDF) 432 Page - Renesas Technology Corp