MB91F613 datasheet(65/104 Pages) FUJITSU

65 / 104 page

MB91610 Series

DS07-16907-2E

(Continued)

*6 : The total average output current is the average current for all pins over a period of 100 ms.

*7 : If the input current or the maximum input current are limited by some means with external components, the

ICLAMP rating supersedes the VI rating.

*8 :

• Corresponding pins:P14 to P17,P20 to P27,P30 to P37,P50 to P57

• Use within recommended operating conditions.

• Use at DC voltage (current).

• The +B signal should always be applied by connecting a limiting resistor between the +B signal and the

microcontroller.

• The value of the limiting resistor should be set so that the current input to the microcontroller pin does not

exceed rated values at any time regardless of instantaneously or constantly when the +B signal is input.

• Note that when the microcontroller drive current is low, such as in the low power consumption modes, the

+B input potential can increase the potential at the VCC pin via a protective diode, possibly affecting other

devices.

• Note that if the +B signal is input when the microcontroller is off (not fixed at 0V), since the power is supplied

through the pin, the microcontroller may operate incompletely.

• Do not leave +B input pins open.

• Sample recommended circuit

WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current,

temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.

P-ch

N-ch

Vcc

•Input/output equivalent circuit

+B input (0 V to 16 V)

Limiting

resistor

Protective diode

ICLAMP

MB91F613 데이터시트(PDF) 65 Page - fujitsu semiconductor