ATmega165 datasheet(151/336 Pages) ATMEL

151 / 336 page

151

ATmega165/V

2573G–AVR–07/09

Note:

1. The baud rate is defined to be the transfer rate in bit per second (bps)

BAUD Baud rate (in bits per second, bps)

OSC

System Oscillator clock frequency

UBRR Contents of the UBRRH and UBRRL Registers, (0-4095)

Some examples of UBRR values for some system clock frequencies are found in Table

72 (see page 171).

Double Speed Operation

(U2X)

The transfer rate can be doubled by setting the U2X bit in UCSRA. Setting this bit only

has effect for the asynchronous operation. Set this bit to zero when using synchronous

operation.

Setting this bit will reduce the divisor of the baud rate divider from 16 to 8, effectively

doubling the transfer rate for asynchronous communication. Note however that the

Receiver will in this case only use half the number of samples (reduced from 16 to 8) for

data sampling and clock recovery, and therefore a more accurate baud rate setting and

system clock are required when this mode is used. For the Transmitter, there are no

downsides.

External Clock

External clocking is used by the synchronous slave modes of operation. The description

in this section refers to Figure 70 for details.

External clock input from the XCK pin is sampled by a synchronization register to mini-

mize the chance of meta-stability. The output from the synchronization register must

then pass through an edge detector before it can be used by the Transmitter and

Receiver. This process introduces a two CPU clock period delay and therefore the max-

imum external XCK clock frequency is limited by the following equation:

Note that f

osc depends on the stability of the system clock source. It is therefore recom-

mended to add some margin to avoid possible loss of data due to frequency variations.

Table 64. Equations for Calculating Baud Rate Register Setting

Operating Mode

Equation for Calculating

Baud Rate(1)

Equation for Calculating

UBRR Value

Asynchronous Normal

mode (U2X = 0)

Asynchronous Double

Speed mode (U2X = 1)

Synchronous Master

mode

BAUD

fOSC

UBRR 1

()

---------------------------------------

UBRR

fOSC

BAUD

------------------------

–

BAUD

fOSC

UBRR 1

()

-----------------------------------

UBRR

fOSC

BAUD

--------------------

–

BAUD

fOSC

UBRR 1

()

-----------------------------------

UBRR

fOSC

BAUD

--------------------

–

fXCK

fOSC

-----------

ATmega165 데이터시트(PDF) 151 Page - ATMEL Corporation

ATmega165 데이터시트(HTML) 151 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL