MC68HC705MC4MP datasheet(127/180 Pages) FREESCALE

127 / 180 page

Serial Communications Interface

SCI Operation

General Release Specification

Serial Communications Interface

11.5.2.4 Receiver Noise Immunity

The data recovery logic samples each bit 16 times to identify and verify

the start bit and to detect noise. Any conflict between noise-detection

samples sets the noise flag (NF) in the SCSR. The NF bit is set at the

same time that the RDRF bit is set.

11.5.2.5 Framing Errors

If the data recovery logic does not detect a logic 1 where the stop bit

should be in an incoming character, it sets the framing error (FE) bit in

the SCSR. The FE bit is set at the same time that the RDRF bit is set.

11.5.2.6 Receiver Interrupts

All SCI interrupt sources share the same interrupt vector at address

$0FF2. The following sources can generate SCI receiver interrupt

requests:

•

Receive Data Register Full (RDRF) — The RDRF bit in the SCSR

indicates that the receive shift register has transferred a character

to the SCDR.

•

Receiver Overrun (OR) — The OR bit in the SCSR indicates that

the receive shift register shifted in a new character before the

previous character was read from the SCDR.

•

Idle Input (IDLE) — The IDLE bit in the SCSR indicates that 10 or

11 consecutive logic 1s shifted in from the PD5/RDI pin.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MC68HC705MC4MP 데이터시트(PDF) 127 Page - Freescale Semiconductor, Inc