P89LPC9211FDH datasheet(47/75 Pages) NXP

47 / 75 page

P89LPC92X1

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 2 — 1 December 2010

47 of 75

NXP Semiconductors

P89LPC9201/9211/922A1/9241/

8-bit microcontroller with 8-bit ADC

temperature. The temperature sensor is measured through Anin03. Anin00, Anin01 and

Anin02 are unused. A block diagram of the ADC is shown in Figure 15 “ADC block

diagram”.

The ADC consists of an 4-input multiplexer which feeds a sample-and-hold circuit

providing an input signal to comparator inputs. The control logic in combination with the

SAR drives a digital-to-analog converter which provides the other input to the comparator.

The output of the comparator is fed to the SAR.

8.2 Features and benefits

8-bit, 4-channel multiplexed input, successive approximation ADC.

On-chip wide range temperature sensor.

Four result registers for each A/D.

Six operating modes:

Fixed channel, single conversion mode.

Fixed channel, continuous conversion mode.

Auto scan, single conversion mode.

Auto scan, continuous conversion mode.

Dual channel, continuous conversion mode.

Single step mode.

Three conversion start modes:

Timer triggered start.

Start immediately.

Edge triggered.

8-bit conversion time of

≥1.61 μs at an A/D clock of 8.0 MHz.

Interrupt or polled operation.

Boundary limits interrupt.

DAC output to a port pin with high output impedance.

Clock divider.

Power-down mode.

P89LPC9211FDH 데이터시트(PDF) 47 Page - NXP Semiconductors