MIC3003GML datasheet(71/75 Pages) MICREL

71 / 75 page

Micrel, Inc.

MIC3003

November 2009

M9999-111209-C

hbwhelp@micrel.com or (408) 955-1690

OEM Configuration 6 (OEMCFG6)

D[7]

read/write

D[6]

read/write

D[5]

read/write

D[4]

read/write

D[3]

read/write

D[2]

read/write

D[1]

read/write

D[0]

read/write

Default value

0000 0000b = 00h

Serial address

A6h

Byte address

27 = 1Bh

This register is non-volatile and will be maintained through power and reset cycles. A valid OEM password is required for access

to these registers.

Bit(s)

Function

Operation

D[7]

A0h space access control

0: A0h space is used according to SFF-8472

1: A0h space does not respond to any access request. SMBus transactions to

A0h receive a NACK response.

D[6:5]

RXPWR Linearization Intervals

00: Temperature-based coefficient selection

01: Programmable delimiters

10: Hard coded delimiters

11: Reserved

Options 01 and 10 partition the receive power result range into eight regions,

each of which has its own slope and offset coefficients. The delimiters identify

the region boundaries within the 12-bit receive power range of results, and

may be either hard-coded (10) or programmable (01).

Use of hard-coded delimiters frees up exta A6 memory space for scratchpad

use.

D[4]

TXDISABLE debounce enable

/ disable

0: TXDISABLE is not debounced

1: TXDISABLE is debounced. Glitches less than 5 ms are rejected.

Set this bit to 1 if a mechanical switch is used for TXDISABLE. Set to 0 for

normal operation to assure compliance to the SFP MSA.

D[3]

RXLOS Polarity

0: The RXLOS output is low for normal operation and high with a loss of signal

condition.

1: The RXLOS output is high for normal operation (signal detected) and low

with a loss of signal (no signal detected) condition.

D[2]

RXLOS/TRSOUT Select

0: RXLOS is selected for output

1: TRRSOUT is selected for output

D[1]

Temperature resolution

0: Temperature is measured to a resolution of 1 ºC (eight-bit resolution)

1: Temperature is measured to a resolution of 0.5 ºC (nine-bit resolution)

D[0]

TXFAULT clear mode

0: TXFAULT remains set until TXDISABLE is toggled

1: TXFAULT is in continuous mode and follows the state of the faults

In continuous mode, the fault conditions asserting TXFAULT are not registered

and turn on and off According to the MIC3003’s operation.

MIC3003GML 데이터시트(PDF) 71 Page - Micrel Semiconductor

MIC3003GML 데이터시트(HTML) 71 Page - Micrel Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

데이터시트 다운로드

링크 URL