BTS6480SF datasheet(21/73 Pages) INFINEON

21 / 73 page

SPOC - BTS6480SF

Power Stages

Data Sheet

Rev. 1.0, 2010-04-12

6.5

External Driver Control

Two external smart power drivers can be driven by the SPOC - BTS6480SF via the external driver control block.

For each external driver there are two control outputs available: one output for controlling the input (EDOx) and

one output for diagnosis enable input (EDDx). The current sense output of the external smart power drivers can

be connected to the IS pin. For details please refer to Figure 30.

The external driver outputs can be used only with applied

DD voltage. The external driver outputs are internally

pulled down. The external drivers can be activated via SPI-bits OUT.OUT4 and OUT.OUT5 or via the input pin

IN3 in assigned drive mode. They will be served as well by the integrated automatic PWM-generation. Therefore,

the according PWM-frequency and duty cycle needs to be programmed.

For performing diagnosis on the external drivers they can be selected via the SPI register DCR.MUX. For being

compliant to PROFET+ diagnostic functions, it is possible to configure pin EDD0 as DEN and EDD1 as DSEL.

Therefore, the bit IECR.PRO+ needs to be set. The DSEL will be set depending on the multiplexer setting

DCR.MUX

Note: The usable duty cycle range and diagnostic timings for the external drivers depend on the external driver’s

characteristics.

Table 3

PROFET+ Compliancy

MUX Setting

DCR.MUX

EDD0 used as DEN

EDD1 used as DSEL

100b

101b

BTS6480SF 데이터시트(PDF) 21 Page - Infineon Technologies AG