MCP3901 datasheet(36/62 Pages) MICROCHIP

36 / 62 page

MCP3901

DS22192D-page 36

6.7

Continuous Communication,

Looping on Address Sets

If the user wishes to read back either of the ADC

channels continuously, or both channels continuously,

the internal address counter of the MCP3901 can be

set to loop on specific register sets. In this case, there

is only one control byte on SDI to start the

communication. The part stays within the same loop

until CS returns high.

This internal address counter allows the following

functionality:

• Read one ADC channel’s data continuously

• Read both ADC channel’s data continuously (both

ADC data can be independent or linked with

DRMODE settings)

• Continuously read the entire register map

• Continuously read each separate register

• Continuously read all Configuration registers

• Write all Configuration registers in one

communication (see Figure 6-7)

The STATUS/COM register contains the loop settings

for the internal address counter (READ<1:0>). The

internal address counter can either stay constant

(READ<1:0> = 00) and continuously read the same

byte, or it can auto-increment and loop through the

map (READ<1:0> = 11).

Each channel is configured independently as either a

16-bit or 24-bit data word, depending on the setting of

the corresponding WIDTH bit in the CONFIG1 register.

For continuous reading, in the case of WIDTH = 0

(16-bit), the lower byte of the ADC data is not accessed

and the part jumps automatically to the following

address (the user does not have to clock out the lower

byte since it becomes undefined for WIDTH = 0).

Figure 6-6

represents

typical,

continuous

read

communication with the default settings (DRMODE<1:0>

= 00, READ<1:0> = 10) for both WIDTH settings. This

configuration is typically used for power metering

applications.

FIGURE 6-6:

Typical Continuous Read Communication.

CH0 ADC

ADDR/R

SCK

SDI

CH0 ADC

Upper byte

SDO

CH0 ADC

Middle byte

CH0 ADC

Lower byte

CH1 ADC

Upper byte

CH1 ADC

Middle byte

CH1 ADC

Lower byte

CH0 ADC

Upper byte

CH0 ADC

Middle byte

CH0 ADC

Lower byte

CH1 ADC

Upper byte

CH1 ADC

Middle byte

CH1 ADC

Lower byte

These bytes are not present when WIDTH=0 (16-bit mode)

MCP3901 데이터시트(PDF) 36 Page - Microchip Technology

MCP3901 데이터시트(HTML) 36 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

데이터시트 다운로드

링크 URL