PCF8531U2DA datasheet(29/51 Pages) NXP

29 / 51 page

PCF8531

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 6 — 16 May 2011

29 of 51

NXP Semiconductors

PCF8531

34 x 128 pixel matrix driver

• Multi-master: more than one master can attempt to control the bus at the same time

without corrupting the message

• Arbitration: procedure to ensure that, if more than one master simultaneously tries to

control the bus, only one is allowed to do so and the message is not corrupted

• Synchronization: procedure to synchronize the clock signals of two or more devices.

10.1.4 Acknowledge

The number of data bytes transferred between the START and STOP conditions from

transmitter to receiver is unlimited. Each byte of eight bits is followed by an acknowledge

cycle.

• A slave receiver which is addressed must generate an acknowledge after the

reception of each byte.

• Also a master receiver must generate an acknowledge after the reception of each

byte that has been clocked out of the slave transmitter.

• The device that acknowledges must pull-down the SDA line during the acknowledge

clock pulse, so that the SDA line is stable LOW during the HIGH period of the

acknowledge related clock pulse (set-up and hold times must be taken into

consideration).

• A master receiver must signal an end of data to the transmitter by not generating an

acknowledge on the last byte that has been clocked out of the slave. In this event the

transmitter must leave the data line HIGH to enable the master to generate a STOP

condition.

Acknowledgement on the I2C-bus is shown in Figure 17.

Fig 16. System configuration

mga807

SDA

SCL

MASTER

TRANSMITTER/

RECEIVER

MASTER

TRANSMITTER

SLAVE

TRANSMITTER/

RECEIVER

SLAVE

RECEIVER

MASTER

TRANSMITTER/

RECEIVER

PCF8531U2DA 데이터시트(PDF) 29 Page - NXP Semiconductors

PCF8531U2DA 데이터시트(HTML) 29 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

데이터시트 다운로드

링크 URL