MLZ2012A3R3W datasheet(25/68 Pages) TI1

25 / 68 page

www.ti.com

Using the Software: ADS1299 Control Registers and GUI

5.5.2

Lead-Off Status Registers (LOFF_STATP and LOFF STATN)

These registers store the output of the lead-off comparator that corresponds with each input. When a lead

is disconnected, the corresponding register bit activates low. The GUI for this feature is enabled by

clicking in the upper right-hand corner of the EVM software on the Show/Poll Lead-Off Status button.

Pressing this button causes a pop-up box that shows the status of the lead-off registers. The GUI shows

when a lead is disconnected by turning its bit from green to red. Figure 26 illustrates the Lead-Off Status

Registers GUI controls.

Figure 26. Lead-Off Status Indicator

5.5.3

Bias Drive Derivation Control Registers

The Bias Drive Derivation Control Registers enable the user to set any combination of positive and/or

negative electrodes to derive the BIAS voltage that is fed to the internal bias drive amplifier. Figure 27

shows the corresponding GUI controls. The details about bias drive can be found in Section 5.5.

SLAU443 – May 2012

EEG Front-End Performance Demonstration Kit

Submit Documentation Feedback

MLZ2012A3R3W 데이터시트(PDF) 25 Page - Texas Instruments