MLZ2012A3R3W datasheet(40/68 Pages) TI1

40 / 68 page

EEG Specific Features

www.ti.com

Figure 46. Scope Tab for Impedance Measurement at fDR/4 (DR = 4ksps)

7.3

External Calibration/Test Signals

ADS1299 generates a square wave test signal that can be used to check the functionality of the signal

chain (Refer to the datasheet for details). It also gives the user an option to provide external test signals

for calibration. For evaluation purposes with the EVM, the test signals can be provided directly to the

jumpers of the corresponding signals. SRB1 (pin2 of JP8), SRB2 (pin3 of JP7), BIASIN (Pin3 of JP6),

BIASREF (does not appear at a jumper, needs to be soldered to one side of R5).

7.3.1

Channel Inputs Disconnected

It may sometimes be required to provide a calibration or test signal to ADS1299 channel without the signal

being routed to the channel input pins (or electrodes). This can be accomplished by applying the positive

test signal to BIASIN pin and the negative test signal to BIASREF pin. The channel multiplexer must be

set as 010, BIASREF_INT bit in Config 3 register must be set to 0 to choose external BIASREF and

BIAS_MEAS bit in Config 3 must be set to 1. These multiplexer settings are illustrated in Figure 47.

EEG Front-End Performance Demonstration Kit

SLAU443 – May 2012

Submit Documentation Feedback

MLZ2012A3R3W 데이터시트(PDF) 40 Page - Texas Instruments