WM9712CLGEFLSLASHV datasheet(53/78 Pages) WOLFSON

53 / 78 page

Production Data

WM9712L

PD, Rev 4.6, November 2011

The properties of the GPIOs are controlled through registers 4Ch to 52h, as shown below.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

4Ch

GCn

GPIO Pin Configuration

0: Output

1: Input

GC11-15 are always ‘1’

Unused bits GC6-GC10 are always ‘0’

4Eh

GPn

GPIO Pin Polarity / Type

0: Active Low

1: Active High

[GIn = pin level XNOR GPn]

Unused bits GP6-GP10 are always ‘1’

50h

GSn

GPIO Pin Sticky

1: Sticky

0: Not Sticky

Unused bits GS6-GS10 are always ‘0’

52h

GWn

GPIO Pin Wake-up

1: Wake Up (generate interrupts from this pin)

0: No wake-up (no interrupts generated)

Unused bits GW6-GW10 are always ‘0’

54h

GIn

N/A

GPIO Pin Status

Read: Returns status of each GPIO pin

Write: Writing ‘0’ clears sticky bit

Unused bits GI6-GI10 are always ‘0’

Table 38 GPIO Control

The following procedure is recommended for handling interrupts:

When the controller receives an interrupt, check register 54h. For each GPIO bit in descending order

of priority, check if the bit is ‘1’. If yes, execute corresponding interrupt routine, then write ‘0’ to

corresponding bit in 54h. If no, continue to next lower priority GPIO. After all GPIOs have been

checked, check if the interrupt still present or no. If yes, repeat procedure. If no, then jump back to

process that ran before the interrupt.

If the system CPU cannot execute such an interrupt routine, it may be preferable to switch internal

signals (such as PENDOWN) directly onto the GPIO pins. However, in this case the interrupt signals

cannot be made sticky, and more GPIO pins are tied up both on the WM9712L and on the CPU.

WM9712CLGEFL/V 데이터시트(PDF) 53 Page - Wolfson Microelectronics plc

WM9712CLGEFL/V 데이터시트(HTML) 53 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78

데이터시트 다운로드

링크 URL