SAM3X datasheet(29/71 Pages) ATMEL

29 / 71 page

11057BS–ATARM–13-Jul-12

SAM3X/A

11057BS–ATARM–13-Jul-12

SAM3X/A

6.4

NRST Pin

The NRST pin is bidirectional. It is handled by the on-chip reset controller and can be driven low

to provide a reset signal to the external components, or asserted low externally to reset the

microcontroller. It will reset the Core and the peripherals except the Backup region (RTC, RTT

and Supply Controller). There is no constraint on the length of the reset pulse, and the reset con-

troller can guarantee a minimum pulse length.

The NRST pin integrates a permanent pull-up resistor to VDDIO of about 100 k

Ω.

6.5

NRSTB Pin

The NRSTB pin is input only and enables asynchronous reset of the SAM3X/A series when

asserted low. The NRSTB pin integrates a permanent pull-up resistor of about 15 k

Ω. This allows

connection of a simple push button on the NRSTB pin as a system-user reset. In all modes, this

pin will reset the chip including the Backup region (RTC, RTT and Supply Controller). It reacts as

the Power-on reset. It can be used as an external system reset source. In harsh environments, it

is recommended to add an external capacitor (10 nF) between NRSTB and VDDBU. (For filter-

ing values, refer to “I/O characteristics” in the “Electrical Characteristics” section of the product

datasheet)

It embeds an anti-glitch filter.

6.6

ERASE Pin

The ERASE pin is used to reinitialize the Flash content (and some of its NVM bits) to an erased

state (all bits read as logic level 1). It integrates a pull-down resistor of about 100 k

Ω to GND, so

that it can be left unconnected for normal operations.

This pin is debounced by SCLK to improve the glitch tolerance. When the ERASE pin is tied high

during less than 100 ms, it is not taken into account. The pin must be tied high during more than

220 ms to perform a Flash erase operation.

The ERASE pin is a system I/O pin and can be used as a standard I/O. At startup, the ERASE

pin is not configured as a PIO pin. If the ERASE pin is used as a standard I/O, the startup level

of this pin must be low to prevent unwanted erasing. Please refer to Section 11.2 “Peripheral

Signal Multiplexing on I/O Lines”. Also, if the ERASE pin is used as a standard I/O output,

asserting the pin to low does not erase the Flash.

SAM3X 데이터시트(PDF) 29 Page - ATMEL Corporation