LIS2DH datasheet(43/50 Pages) STMICROELECTRONICS

43 / 50 page

LIS2DH

Registers Description

Doc ID 022516 Rev 1

43/49

Interrupt 2 source register. Read only register.

Reading at this address clears INT2_SRC IA bit (and the interrupt signal on INT 2 pin) and

allows the refreshment of data in the INT2_SRC register if the latched option was chosen.

7.25

INT2_THS (36h)

7.26

INT2_DURATION (37h)

D6 - D0 bits set the minimum duration of the Interrupt 2 event to be recognized. Duration

time steps and maximum values depend on the ODR chosen.

Y low. Default value: 0

(0: no interrupt, 1: Y low event has occurred)

X high. Default value: 0

(0: no interrupt, 1: X high event has occurred)

X Low. Default value: 0

(0: no interrupt, 1: X low event has occurred)

Table 62.

INT2_SRC description (continued)

Table 63.

INT2_THS register

THS6

THS5

THS4

THS3

THS2

THS1

THS0

Table 64.

INT2_THS description

THS6 - THS0

Interrupt 2 threshold. Default value: 000 0000

1LSb = 16mg @FS=2g;

1LSb = 32mg @FS=4g;

1LSb = 62mg @FS=8g;

1LSb = 186mg @ FS=16g

Table 65.

INT2_DURATION register

D5D4D3

D2D1

Table 66.

INT2_DURATION description

D6-D0

Duration value. Default value: 000 0000

1 LSb = 1/ODR(1)

1. Duration time is measured in N/ODR, where N is the content of the duration register.

LIS2DH 데이터시트(PDF) 43 Page - STMicroelectronics

LIS2DH 데이터시트(HTML) 43 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

데이터시트 다운로드

링크 URL