MPC8241EC datasheet(24/58 Pages) FREESCALE

24 / 58 page

MPC8241 Integrated Processor Hardware Specifications, Rev. 10

Freescale Semiconductor

Electrical and Thermal Characteristics

Figure 14 provides the AC test load for the MPC8241.

Figure 14. AC Test Load for the MPC8241

14b

sys_logic_clk to output high impedance (for all others)

—

4.0

Notes:

1. All PCI signals are measured from GVDD_OVDD/2 of the rising edge of PCI_SYNC_IN to 0.285 × GVDD_OVDD or 0.615 ×

GVDD_OVDD of the signal in question for 3.3 V PCI signaling levels. See Figure 12.

2. All memory and related interface output signal specifications are specified from the VM = 1.4 V of the rising edge of the

memory bus clock, sys_logic_clk to the TTL level (0.8 or 2.0 V) of the signal in question. sys_logic_clk is the same as

PCI_SYNC_IN in 1:1 mode, but is twice the frequency in 2:1 mode (processor/memory bus clock rising edges occur on every

rising and falling edge of PCI_SYNC_IN). See Figure 11.

3. PCI bused signals are composed of the following signals: LOCK, IRDY, C/BE[3:0], PAR, TRDY, FRAME, STOP, DEVSEL,

PERR, SERR, AD[31:0], REQ[4:0], GNT[4:0], IDSEL, and INTA.

4. To meet minimum output hold specifications relative to PCI_SYNC_IN for both 33- and 66-MHz PCI systems, the MPC8241

has a programmable output hold delay for PCI signals (the PCI_SYNC_IN to output valid timing is also affected). The initial

value of the output hold delay is determined by the values on the MCP and CKE reset configuration signals; the values on

these two signals are inverted and subsequently stored as the initial settings of PCI_HOLD_DEL = PMCR2[5, 4] (power

management configuration register 2 <0x72>), respectively. Because MCP and CKE have internal pull-up resistors, the

default value of PCI_HOLD_DEL after reset is 0b00. Additional output hold delay values are available by programming the

PCI_HOLD_DEL value of the PMCR2 configuration register. See Figure 15 for PCI_HOLD_DEL effect on output valid and

hold time.

Table 11. Output AC Timing Specifications (continued)

Num

Characteristic

Min

Max

Unit

Notes

Output

Z0 = 50 Ω

GVDD_OVDD/2 for

RL = 50 Ω

Output Measurements are Made at the Device Pin

PCI or Memory

MPC8241EC 데이터시트(PDF) 24 Page - Freescale Semiconductor, Inc