STM32F101RBH6 datasheet(85/90 Pages) STMICROELECTRONICS

85 / 90 page

DocID13586 Rev 16

85/90

STM32F101x8, STM32F101xB

Revision history

22-Nov-2007

Document status promoted from preliminary data to datasheet. Small text

changes.

STM32F101CB part number corrected in Table 1: Device summary.

Number of communication peripherals corrected for STM32F101Tx in

Table 2: Device features and peripheral counts (STM32F101xx medium-

density access line) and Number of GPIOs corrected for LQFP package.

Power supply schemes on page 16 modified.

Main function and default alternate function modified for PC14 and PC15

in Table 4: Medium-density STM32F101xx pin definitions, Note 6 added,

Remap column added.

Figure 11: Power supply scheme modified. VDD VSS ratings modified

and Note 1 modified in Table 5: Voltage characteristics. Note 1 modified in

Table 6: Current characteristics.

Note 2 added in Table 10: Embedded reset and power control block

characteristics.

48 and 72 MHz frequencies removed from Table 12, Table 13 and

Table 14. MCU ‘s operating conditions modified in Typical current

consumption on page 42.

IDD_VBAT typical value at 2.4 V modified and IDD_VBAT maximum value

added in Table 15: Typical and maximum current consumptions in Stop

and Standby modes. Note added in Table 16 on page 42 and Table 17 on

page 43. Table 18: Peripheral current consumption modified.

Figure 17: Typical current consumption in Stop mode with regulator in

Low-power mode versus temperature at VDD = 3.3 V and 3.6 V added.

Note removed below Figure 30: SPI timing diagram - slave mode and

CPHA = 0. Note added below Figure 31: SPI timing diagram - slave mode

and CPHA = 1(1).

Figure 34: Typical connection diagram using the ADC modified.

tSU(HSE) and tSU(LSE) conditions modified in Table 21 and Table 22,

respectively. Maximum values removed from Table 25: Low-power mode

wakeup timings. tRET conditions modified in Table 28: Flash memory

endurance and data retention. Conditions modified in Table 29: EMS

characteristics.

Impedance size specified in A.4: Voltage glitch on ADC input 0 on

page 71. Small text changes in Table 35: Output voltage characteristics.

Section 5.3.11: Absolute maximum ratings (electrical sensitivity) updated.

Details on unused pins removed from General input/output characteristics

on page 55.

Table 41: SPI characteristics updated. Notes added and Ilkg removed in

Table 42: ADC characteristics. Note added in Table 43 and Table 46.

Note 3 and Note 2 added below Table 44: ADC accuracy - limited test

conditions. Avg_Slope and V25 modified in Table 46: TS characteristics.

JAvalue for VFQFPN36 package added in Table 52: Package thermal

characteristics

I2C interface characteristics on page 62 modified.

Order codes replaced by Section 7: Ordering information scheme.

Table 54. Document revision history (continued)

Date

Revision

Changes

STM32F101RBH6 데이터시트(PDF) 85 Page - STMicroelectronics

STM32F101RBH6 데이터시트(HTML) 85 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

데이터시트 다운로드

링크 URL