30F4013 datasheet(101/228 Pages) MICROCHIP

101 / 228 page

 2010 Microchip Technology Inc.

DS70138G-page 101

dsPIC30F3014/4013

15.3

Slave Select Synchronization

The SSx pin allows a Synchronous Slave mode. The

SPI must be configured in SPI Slave mode with SSx pin

control enabled (SSEN = 1). When the SSx pin is low,

transmission and reception are enabled and the SDOx

pin is driven. When SSx pin goes high, the SDOx pin is

no longer driven. Also, the SPI module is resynchro-

nized, and all counters/control circuitry are reset.

Therefore, when the SSx pin is asserted low again,

transmission/reception begins at the MSb even if SSx

had been deasserted in the middle of a transmit/

receive.

15.4

SPI Operation During CPU Sleep

Mode

During Sleep mode, the SPI module is shut down. If the

CPU enters Sleep mode while an SPI transaction is in

progress, then the transmission and reception is

aborted.

The transmitter and receiver stop in Sleep mode.

However, register contents are not affected by entering

or exiting Sleep mode.

15.5

SPI Operation During CPU Idle

Mode

When the device enters Idle mode, all clock sources

remain functional. The SPISIDL bit (SPIxSTAT<13>)

determines if the SPI module stops or continues on

Idle. If SPISIDL = 0, the module continues to operate

when the CPU enters Idle mode. If SPISIDL = 1, the

module stops when the CPU enters Idle mode.

30F4013 데이터시트(PDF) 101 Page - Microchip Technology