IO96PDB2V1 datasheet(149/242 Pages) MICROSEMI

149 / 242 page

ProASIC3L Low Power Flash FPGAs

Revision 13

2-133

Table 2-213 • ProASIC3L CCC/PLL Specification

CCC/PLL Operating at 1.5 V

Parameter

Min.

Typ.

Max.

Units

Clock Conditioning Circuitry Input Frequency fIN_CCC

1.5

350

MHz

Clock Conditioning Circuitry Output Frequency fOUT_CCC

0.75

350

MHz

Delay Increments in Programmable Delay Blocks 1, 2

1603

Serial Clock (SCLK) for Dynamic PLL 4

110

Number of Programmable Values in Each Programmable Delay Block

Input Period Jitter

1.5

CCC Output Peak-to-Peak Period Jitter FCCC_OUT

Max Peak-to-Peak Period Jitter

1 Global

Network

Used

3 Global

Networks

Used

0.75 MHz to 24 MHz

0.50%

0.70%

24 MHz to 100 MHz

1.00%

1.20%

100 MHz to 250 MHz

1.75%

2.00

250 MHz to 350 MHz

2.50%

5.60%

Acquisition Time

LockControl = 0

300

µs

LockControl = 1

6.0

Tracking Jitter5

LockControl = 0

1.6

LockControl = 1

0.8

Output Duty Cycle

48.5

51.5

Delay Range in Block: Programmable Delay 1 1, 2

0.6

5.56

Delay Range in Block: Programmable Delay 2 1, 2

0.025

5.56

Delay Range in Block: Fixed Delay 1, 2

2.2

Notes:

1. This delay is a function of voltage and temperature. See Table 2-6 on page 2-7 for deratings.

2. TJ = 25°C, VCC = 1.5 V

3. When the CCC/PLL core is generated by Microsemi core generator software, not all delay values of the specified delay

increments are available. Refer to the Libero SoC Online Help for more information.

4. Maximum value obtained for a –1 speed grade device in worst-case commercial conditions. For specific junction

temperature and voltage supply levels, refer to Table 2-6 on page 2-7 for derating values.

5. Tracking jitter is defined as the variation in clock edge position of PLL outputs with reference to PLL input clock edge.

Tracking jitter does not measure the variation in PLL output period, which is covered by the period jitter parameter.

Note: Peak-to-peak jitter measurements are defined by Tpeak-to-peak = Tperiod_max – Tperiod_min.

Figure 2-40 • Peak-to-Peak Jitter Definition

Tperiod_max

Tperiod_min

Output Signal

IO96PDB2V1 데이터시트(PDF) 149 Page - Microsemi Corporation

IO96PDB2V1 데이터시트(HTML) 149 Page - Microsemi Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL