AT25DF641_13 datasheet(9/56 Pages) ETC2

9 / 56 page

AT25DF641

3680F–DFLASH–4/10

Read Commands

6.1.

Read Array

The Read Array command can be us ed to sequentially read a c ontinuous stream of data from the device by

simply providing the clock signal once the initial starting address has been specified. The device incorporates an

internal address counter that automatically increments on every clock cycle.

Three opcodes (1Bh, 0Bh, and 03h) can be used for the Read Array command. The use of each opcode depends

on the maximum clock frequency that will be used to read data from the device. The 0Bh opcode can be used at

any clock frequency up to the maximum specified by fCLK, and the 03h opcode can be used for lower frequency

read operations up to the maximum specified by fRDLF. The 1Bh opcode allows the highest read performance

possible and can be used at any clock frequency up to the maximum specified by fMAX; however, use of the 1Bh

opcode at clock frequencies above fCLK should be reserved to systems employing the RapidS protocol.

To perform the Read Array operation, the

pin must first be asserted and the appropriate opcode (1Bh, 0Bh, or

03h) must be clocked into the device. After the opcode has been clocked in, the three address bytes must be

clocked in to specify the starting address location of the first byte to read within the memory array. Following the

three address bytes, additional dummy bytes may need to be clocked into the device depending on which opcode

is used for the Read Array operation. If the 1Bh opcode is used, then two dummy bytes must be clocked into the

device after the three address bytes. If the 0Bh opcode is used, then a single dummy byte must be clocked in

after the address bytes.

After the three address bytes (and the dummy bytes or byte if using opcodes 1Bh or 0Bh) have been clocked in,

additional clock cycles will result in data being output on the SO pin. The data is always output with the MSB of a

byte first. When the last byte (7FFFFFh) of the memory array has been r ead, the device will continue reading

back at the beginning of the array (000000h). No delays will be incurred when wrapping around from the end of

the array to the beginning of the array.

Deasserting the

pin will terminate the read operation and put the SO pin into a high-impedance state. The

pin can be deasserted at any time and does not require that a full byte of data be read.

Figure 6-1.

Read Array - 1Bh Opcode

SCK

MS B

10 11

42 43

37 38

31 32

29 30

47 48

50 51

55 56

OPCODE

MS B

D D D D D D D D

ADDR E S S BITS A23-A0

DON'T CAR E

MS B

DON'T CAR E

DATA BYTE 1

HIGH-IMPE DANCE

AT25DF641 데이터시트(PDF) 9 Page - List of Unclassifed Manufacturers

AT25DF641 데이터시트(HTML) 9 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

데이터시트 다운로드

링크 URL